Remove the radiator system cooling. Detach from the thermostat housing, the exhaust pipe of the cylinder head and pipe water pump cooling system hoses. Ignition Coil Renault Logan free from harness pads wire engine management system, idling regulator, fuel injectors, solenoid valve and canister purge sensors: oxygen, detonation, and the absolute air pressure air temperature in the intake pipe, signaling the lack of oil pressure, coolant temperature, crankshaft position, throttle position. Allot wiring harnesses from the engine side. If the engine is supposed to be removed from the engine compartment up with a lifting device, you first need to remove the gearbox.

Raise the hood on the Renault Logan and hold it vertically position. Fasten the chain hoist to the engine mounts. Pulling the chain, we remove the stress from the engine, which had supported him when removing the gearbox. On the right pole of the power unit remove the holder canister purge tube and allot up to one side, remove the extension and turn away the two screws attaching the right support to the body. Before removing the engine, you need to check again that all hoses, pipes, wires disconnected from the engine and taken away.

With the help of winches raise and remove the engine from the engine compartment. If the work is done on a lift and remove the power unit down, the generator is not dismantled need – just unplug it from the wire. You can also disassemble the engine power steering pump and air conditioner compressor, and a disconnect from their pipes and hoses. When removing powertrain operations, instead of lifting gear must perform the following work. Remove the front wheel drive. Disconnect the cable from the drive clutch fork clutch mechanism and bracket on the gearbox. Disconnect the traction control transmission of the transmission shift rod. Disconnect the "mass" and the wire harness from the transmission. Remove the speed sensor. Detach block of wires from a light switch reverse. Set up under the engine and gearbox adjustable stops or sturdy table. Remove the right-hand pillar of the power unit. Turn away nut left support power unit to the bracket support. Remove the engine. Set the engine or power plant on Renault Logan in reverse order.